|
This
Tube Notcher is capable
of cutting fishmouths in tube and pipe ranging in diameters from Ø12.7mm
(½") to Ø50.08mm (2") with any wall thickness. It will easily cut at any
angle from 0° to 50°.
The quality needle roller bearings specified will ensure concentricity and
long life. No chattering and poorly cut fishmouths like the cheap bought
tools!
The
Notcher is ideally suited to anyone wanting to accurately fabricate tubular
structures such as gates, motorcycle frames, buggy chassis etc. The
Notcher can be quickly mounted in a vice for occasional use
with a hand drill, or
attached to the table of a pedestal drill for more permanent use.
The
Notcher is designed with the utmost simplicity of construction in mind. In
most instances, the main parts of the
Notcher can be made from common steel
off-cuts found in the average workshop. A lathe (or access to one) is
necessary for boring the hole in the bearing block and turning the reduced
shank and threads on the shaft.
The
only other tools required are a scriber or craft knife, a tape measure, a
compass, a protractor, a setsquare, an adjustable bevel, a centre punch, a
jigsaw or bandsaw, a hacksaw or cut-off saw, a pedestal or hand drill,
Ø8.5mm, Ø10.2mm, Ø10.5mm drill bits, M10 and M12 taps, a welder, and an
angle grinder or file for finishing.
More than just a
collection of CAD drawings,
this comprehensive manual
consists of the following:
- Sixteen
pages of instructions.
- Ten
2D and 3D
CAD drawings.
- Full materials
list.
- Full fasteners
list.
US Supplier Of Suitable Materials
Instructional videos and DVDs
Purchase
The Tube Notcher Manual Now |
