|
"I
have seen a lot of plans but yours are fantastic."
DeWayne
Young - Foster Marine
Limited, Guernsey, Channel Islands
"Great
package. Wish all transactions were this quick and
easy. Two thumbs up!"
K. Sherret - Ontario,
Canada
"Thanks
for the plans. Absolutely amazing.
Well laid out and simple to understand."
M.
Jakic - Ontario,
Canada
"(The)
tube bender design is a work of art....it
is a superior design compared to what
I have seen..."
C. Passmore -
New York, USA
This
Tube Bender is capable of bending
light precision tube
(not pipe) of the following
diameters:
31.8mm (1¼”), 38.1mm
(1½”), 44.45mm (1 ¾”) and 50.08mm (2”). Smaller sizes can also be
accommodated by making additional die sets.
The No. 2 Bender is
basically the same as the No.1 Bender
but is more brutish; better suited to
bending larger diameter tubes. The only part shared with the No. 1
Bender is the handle.
The tube bending dies necessitate
being turned on a lathe, but even a wood lathe can be employed to make the
dies if preferred. The only other tools required are a scriber or craft
knife, a tape measure, a setsquare, an adjustable bevel, a
cut-off saw (or hacksaw), a pedestal
drill (or hand drill), 8mm, 12mm, 19mm, 20mm, 24mm drill
bits, a welder, and an angle grinder or file for finishing.
More than just a
collection of CAD drawings,
this comprehensive PDF Manual
consists of the following:
-
Thirty pages.
-
Twelve
CAD drawings.
-
Eighteen
polychrome 3D CAD images.
-
Full materials list.
-
Full fasteners list.
US Supplier Of Suitable Materials
Purchase The No.2 Bender Manual Now |
