|
"Finally
got it finished, works a treat!"
J. R. - Queensland, Australia
This Ring Roller is capable
of rolling RHS (square tube) and other square and rectangular bar up to 75mm (3.0")
wide. The maximum height of the gullet is 50mm (2.0").
By simply
adjusting the height of the roller wheel, spacing the idler shafts and then
cranking the handle, you can produce long slow bends and rings in plain
steel or aluminium sections and bars.
The specified heavy duty
self-aligning bearings will ensure smooth operation and long life.
The Ring Roller is ideally
suited to anyone wanting to accurately fabricate parts or structures such as
gates, horse floats, garden furniture, architectural fittings, etc. The ring
roller can be easily mounted to the edge of a table or bench by bolting down
through the feet.
The Ring Roller is designed
with the utmost simplicity of construction and operation in mind. In most
instances, the main parts of the ring roller can be made from common steel
off-cuts found in the average workshop. A lathe (or access to one) is
necessary for turning the roller wheel etc., but no milling is necessary to
complete the machine.
The only other tools
required are a scriber or craft knife, a tape measure, a setsquare, an
adjustable bevel, a centre punch, a hacksaw or cut-off saw, a pedestal or
hand drill, Ø6.8mm, Ø8.5mm, Ø12.5mm drill bits, M10 tap, a welder, and an
angle grinder or file for finishing.
More than just a
collection of CAD drawings,
this comprehensive PDF
Manual
consists of the following:
- Twenty
seven
pages of instructions.
-
Fifteen
CAD drawings.
- Full materials
list.
- Full fasteners
list.
US Supplier Of Suitable Materials
Purchase The Ring Roller Manual Now |
