|
"No worries mate!
Great design and plans. Thank you very much."
T. Rayner
- Florida, USA
"Good useful plans..sent
immediately.."
Chris Dunn,
Diamond Hill Blacksmith -
Washington, USA
"These drawings along with the detail information is great, top notch work.
I do ornamental iron work and have been looking for something like this to
get the job done but without the heavy equipment cost."
E. W. - Berea, OH USA
This
Roll Bender will bend
long slow curves of varying Centre Line Radii in just about any section of
ferrous and non-ferrous material with precision and relative ease. Radii
greater than 100mm and angles from zero to 360° (hoops and rings) can be
achieved.
The round tube die drawings included in the plans are:
25.4mm (1”), 31.8mm (1 ¼”), 38.1mm (1 ½”), 44.45mm (1 ¾”) and 50.8mm (2”).
There are also drawings for a multi-die set-up that will roll round bar of
varying diameters, and flat bar (both the “easy way” and the “hard way”).
Many other sizes and sections can be accommodated by making additional dies.
Handling angles and square section/tube are all possibilities with this
model.
, and an angle grinder or file for finishing.
Some typical uses are:
- Architectural fittings.
- Curved roof sections of car roll cages.
- Handrails.
- Livestock equipment.
- Ornamental ironwork.
- Motorcycle frames.
- Tubular furniture.
- And of course buggies!
More than just a
collection of CAD drawings,
this comprehensive PDF Manual
consists of the following:
|
